This is an odorless, non-toxic inkjet pretreatment designed to be used with any DTG printer. Magic Spray White will increase color intensity and improve wash fastness.
No longer is your choice only DuPont for a good pretreat solution. Lawson's Magic Spray White & CMYK has the latest cutting-edge formulation. Magic Spray is not just a repackage of older formulations, but a new product matched to the latest DTG ink formulations. Try it once and if the quality doesn't change your mind (better wash-fastness and less cracking), the price and consistency of the product will.
Important Application Directions: Magic Spray can be applied with any automatic spray unit, like the Lawson Pre-Treat Express or Select automatic spray system, or can be applied by hand with a mist sprayer, pump sprayer, airbrush or garden sprayer, etc.
Spray an even coat of pretreat solution in the print location. Do not over saturate the garment. Dry pretreat solution with a specialized conveyor dryer (like the Lawson Pioneer/Digi-Star or Omega System 3 Dryer) or by using a heat transfer press.
Curing: When using a heat transfer press to dry, DO NOT use a Teflon sheet or silicone treated parchment paper to protect the garment, and DO NOT clamp the heat transfer press too tight. Simply lower the press to set on top of the garment and use a plain paper (or non-silicone treated parchment) as a protective sheet. Press the garment for 10 seconds at 330°F. Remove the pretreatment paper and then press for an additional 10 - 15 seconds.
Too much pretreatment may leave a Lighter garment colors require less pretreatment than black or navy. Garments can be pretreated in advance in batches before final printing.
Curing Finished Print: Fully printed shirts must be heat cured at 330°F (165°C) for at least 60 to 180 seconds (depending on the shirt color and ink you are using) with a heat transfer press, using medium to heavy pressure with silicone treated parchment paper cover; heat transfer paper; or for glossy prints, a Teflon sheet.
Warning: This pretreatment is designed to have a chemical reaction with the White ink. It is VERY IMPORTANT that the print head does NOT touch a pretreated garment or this chemical reaction can take place in the print head and permanently clog it. Always check the print head and garment clearance before printing. Handling: Occasional use of this product can be done without personal protective equipment. For continued application by hand, use goggles, rubber gloves and vapor mask for user comfort and protection. USE ADEQUATE VENTILATION WHEN USING THIS PRODUCT.
Storage: Keep tightly capped in a cool, 50-100°F (19-38°C) area.
Washability: Wash garments inside out in cold water using a delicate setting on dryer.